Datasheet

1
8
Preparation
Conductor termination with . . .
. . . operating tool
WINSTA
®
MINI, 890 Series
Handling:
Latch wired connector onto the base of the strain relief housing. To terminate fine-stranded conductors, open clamping unit via
2.5 mm screwdriver and insert stripped conductor until it hits
backstop.
Solid conductors can be connected via push-in termination.
1. Strip length, outer insulation = x mm
1
2. Strip length = 9 mm
3. Extended ground conductor = 8 mm
To terminate fine-stranded conductors, open clamping units via
890-382 Operating Tool and insert stripped conductors until
they hit backstop.
Solid conductors can be connected via push-in termination.
To terminate fine-stranded conductors, open clamping units via
890-383 Operating Tool and insert stripped conductors until
they hit backstop.
Solid conductors can be connected via push-in termination.
Termination via Push-in CAGE CLAMP
®
Strain relief installation
Shield termination
Push the shield connecting plate into the connector until fully
inserted.
Apply the shield to the rubber cable.
Strip length, outer insulation = 30 mm
Shield length = 8 mm
Connector with shield termination
1 Strip length, outer insulation: 2-pole = 30 mm, 3-pole = 37 mm, 4- and 5-pole = 45 mm