Datasheet

3
116
WINSTA
®
MIDI
IP 2XD, for Easily Accessible Areas
Strain relief installation
Strain relief removal
First, unlock strain relief clamp via 2.5 mm screwdriver from the
bottom.
Finally, unlock strain relief housing via 2.5 mm screwdriver on
both sides.
Then, push strain relief clamp via 2.5 mm screwdriver out of the
locking position.
To terminate fine-stranded conductors, open clamping unit via
2.5 mm screwdriver and insert stripped conductor until it hits
backstop.
Solid conductors can be connected via push-in termination.
Insert wired connector onto the base of the strain relief housing.
Prepare strain relief housing by snapping together upper and
bottom part.
Push down strain relief clamp via 2.5 mm screwdriver alternately
on both sides.
1. Strip length, outer insulation = 48 mm
2. Strip length: = 9 mm
3. Extended ground conductor = 8 mm