Datasheet

8
214
Preparation
WINSTA
®
KNX, 893 Series
Handling:
Strain relief assembly
Snap wired connector into strain relief housing. Press strain relief firmly on the cable. Pre-assembled KNX connector
To disconnect, open clamping unit using the actuator and pull out
the conductor.
Push conductors until they hit backstop.
Insert stripped conductor directly into the conductor entry.Prior to termination, pull the strain relief housing over the cable. 1. Strip length, outer insulation: = 23 mm
2. Strip length = 9 mm
Conductor termination
Conductor termination