Datasheet

9
222
Module positioning and contacting
Mounting plate installation
Snapping on distribution connector
WINSTA
®
IDC, 772 Series
Handling:
After connecting the flat cable, the IDC module is locked and can
no longer be moved, even after unscrewing the contact element.
Screw down contact elements until element stops. Mount IDC module flush with the base.
Should the IDC module jam during mounting, turn the upper part
by 180° and remount it.
Insert flat cable into base (observe coding!).
The mounting plate can be centrally mounted, or attached via
outboard attachment points using 770-601 Fixing Pins.
The distribution connectors snap together when attached to the
mounting plate.
Move the phase selector into position L1 or L3 if required.
Phase selection
The phase selector is in position L2 (center) when delivered.