Datasheet

12
288
Question 1:
Can WINSTA
®
be used in low-voltage range applications?
Compliance of the WINSTA
®
products with the low-voltage directive is contained within the CE approval.
Question 2:
Can I wire the entire electrical installation of a functional building using WINSTA
®
?
The WINSTA
®
system allows the entire electrical installation to be wired on both sides of the floor distribution boards.
Question 3:
What needs to be considered for the changeover from NYM cables for permanent installation
to pluggable installation using fine-stranded wires?
The changeover area must be fixed properly in order to protect the NYM cable from too high bending stress. In addition, all terminals must be
protected against shear and tensile stress.
Question 4:
What needs to be considered when there is a concentration of WINSTA
®
cables, e.g. in a
cable duct?
As a result of the heat build-up, it might be necessary to reduce the current carrying capacity or to increase the cross section from e.g.
2.5 mm
2
to 4 mm
2
(14 to 12 AWG).
Question 5:
Where may I use WINSTA
®
for installation?
Anywhere there is enough space for connectors and cables, e.g. in cable ducts, false floors or plasterboard walls and suspended ceilings.
The provisions set out in VDE 0100 must always be observed.
Question 6:
What needs to be considered if there is a cross section reduction?
The minimum conductor cross section must be adapted to the connected load. More protection measures are only required if the cable with the
reduced cross section to the connected load is longer than 3m (see VDE 0100, Nov. 1991, Part 430).
Question 7:
Are there distribution boxes with WINS TA
®
components available?
Yes. WAGO offers a variety of distribution boxes with different functions (e.g., DALI-Bus, KNX applications, sun blind control) ready for connection
with WINSTA
®
Pluggable Connectors.
Question 8:
May I split a three-phase circuit using WINSTA
®
?
It must be ensured that all three phases can be simultaneously switched off (e.g., via 3-pole safety cutout or circuit breaker). WINSTA
®
offers several
convenient solutions, such as three-phase to single-phase distribution connectors, distribution connectors with phase selection, intermediate couplers
from 5 poles to 3 poles and customized distribution boxes.
WINSTA
®
Your Questions – Our Answers
For more information go to: www.wago.com