Datasheet

10 20 30 40 50 60 70 80 90 100105
0
5
10
15
20
2-, 4-, 6-
Current-Carrying Capacity Curve
Pin spacing: 6 mm / Conductor size 1.5 mm
2
“f-st”
Based on: EN 60512-5-2 / Reduction factor: 1
Current in A
Ambient operating temperature in °C
Conductor rated current
pole
34
2
Volume 2
THR PCB Terminal Blocks with Push-Buttons, 1.5 mm
2
Pin Spacing: 6 mm
2061 Series
Technical data:
Pin Spacing
6 mm / 0.24 in.
Ratings per
IEC/EN 60664-1
Overvoltage category
III III II
Pollution degree
3 2 2
Rated voltage
250 V 320 V 630 V
Rated impulse voltage
4 kV 4 kV 4 kV
Nominal current
17.5 A 17.5 A 17.5 A
Material data:
Material group I
Insulation material Glass-fiber-reinforced polyphthalamide (PPA-GF)
Flammability rating per UL 94 V0
Lower/Upper limit temperature -60 °C / +105 °C
Contact material Copper alloy
Contact plating Tin-plated
Conductor data:
Connection technology CAGE CLAMP
®
S
Conductor size: solid 0.5 … 1.5 mm
2
Conductor size: fine-stranded 0.5 … 1.5 mm
2
Conductor size: fine-stranded 0.5 … 0.75 mm
2
(with insulated ferrule)
Conductor size: fine-stranded 0.5 … 0.75 mm
2
(with uninsulated ferrule)
AWG 20 … 16
Strip length 7 … 10 mm / 0.28 … 0.39 in.
Conductor entry 0° to PCB
Solder pin: length/width 2.4 mm / 1.2 x 0.35 mm
Solder pin: length/width 1.5 mm / 1.2 x 0.35 mm
Solder pin: metal-plated hole 1.5
+0.1
mm Ø
Outer diameter of metal-plated PCB hole min. 2.4 mm
●
THR PCB terminal blocks with Push-in CAGE CLAMP
®
and push-buttons
● Push-in termination of solid and ferruled conductors
● Push-buttons simplify termination/removal of all conductor types
● Just 5.6 mm tall
● Available in tape-and-reel packaging for automated assembly
● Also suitable for wave soldering
● Arrange groups of terminal blocks without pole loss
Application note:
Suitable for lead-free, reflow-soldering profiles acc. to DIN EN 61760-1 and IEC 60068-2-58 up to max. 260 °C peak
temperature. Due to customer-specific variables (e.g., component configuration and orientation, soldering machine type,
solder paste), trial runs are recommended to ensure product and process compatibility under actual manufacturing condi-
tions.

Recommendation for stencil: 150µm material thickness
The stencil hole diameter is identical to the outer diameter of the metal-plated PCB hole.
2061 Series accessories: Volume 2/Page:
Operating tool (206-861) 218
Operating tool (2061-189) 218
Approvals are available online at: www.wago.com For more technical information, see Full Line Catalog, Volume 2, Section 13