Datasheet

Data sheet | Item number:832-3606
www.wago.com/832-3606
10.05.2019Page /2 4
Male header may be mounted horizontally or vertically via straight or angled solder pins
Three solder pins per pole provide high electrical and mechanical stability
Mating face (IP2XB) with higher protection against accidental contact
100% protected against mismating
Coding via coding fingers
Safety information 1:
The is designed without breaking capacity for compliance with DIN EN 61984. When used as intended, MCS MULTI CONNECTION SYSTEM (MCS)
Connectors shall not be connected/disconnected when live or under load. The circuit design should ensure header pins, which can be touched, are
not live when unmated.
Data
Electrical data
Ratings per IEC/EN 60664-1
Rated voltage (III / 3) 800 V
Rated impulse voltage (III / 3) 8 kV
Rated voltage (III / 2) 1000 V
Rated impulse voltage (III / 2) 8 kV
Rated voltage (II / 2) 1000 V
Rated impulse voltage (II / 2) 8 kV
Rated current 76 A
Connection data
No. of poles 6
Total number of potentials 6
Number of connection types 1
Number of levels 1
Geometrical Data
Pin spacing 10.16mm/ 0.4inch
Width 62.26mm/ 2.451inch
Height 36mm/ 1.417inch
Height from the surface 32mm/ 1.26inch
Depth 16.5mm/ 0.65inch
Solder pin length 4 mm
Solder pin dimensions 1.2 x 1.2mm
Drilled hole diameter (tolerance)
1.7 mm
(- … +0.1)