Technical data

52 • Feldbus Coupler 750-344 / -345
Operating system
WAGO-I/O-SYSTEM 750
INTERBUS
3.1.3 Operating system
The system can be started up after configuring the INTERBUS Master system
and after electrical installation of the fieldbus station.
The coupler checks the data bus when power is applied. Following this the I/O
modules and the present configuration is determined. At the same time, a list
is generated which is not visible from outside. This includes an input and an
output area, which is shown on the fieldbus RAM of the protocol chip.
In the event of an error the coupler switches to "Stop". The I/O LED flashes
red. After a trouble-free startup, the coupler enters the "Fieldbus start" mode
and the I/O LED lights up green.
Fig. 3-7: Operating system - Power on g012113e