Specifications

4
Complete Calibration Services Available
Wahl
®
DST500
DSX500
10/08
172 Y
ears of Continued Innovation
ISO9001:2000 CERTIFIED
[phone] • FAX [phone] • www.palmerwahl.com
Calibration and Programming
Software and Accessories
Meter Calibration of a Digi-Stem Meter
utilizing a decade box and DST/USB Inter
face Module.
DST500/DSX500 Fixed Probe Calibration Cable Assembly -
13500-03 Extends the probe leads when performing system
calibrations on fixed probe systems. Allows the meter to be
conveniently placed on the benchtop, while the probe is
installed in an ice bath.
DST500/DSX500 Interconnect Calibration Cable - When probe
wiring is difficult to remove, simply disconnect the probe and
meter from the cable, and use the 2 meter interconnect cable
for performing lab calibration.
System Calibration of a Remote Digi-Stem utilizing an ice bath and
DST/USB Interface Module.
Software Accessories
Ice Bath
Decade Box
Wahl DSTPROG and DSTCAL Software Kits are user
friendly and include on-screen prompts for guiding the
user through their operation. Both Kits require Windows
XP to operate,
and include a
USB cable,
DST/USB
Interface
Module, and
Digi-Stem Serial
Interface Cable
in order to
connect the
Wahl DST &
DSX500 to a PC.
DSTCAL Calibration Software Kit - This exclusive software
allows setting of the same configuration parameters as
DSTPROG, but also allows the following calibrations:
• Meter Calibration - uses fixed resistances to calibrate the
resistance measurement electronics by connecting to
known fixed resistances.
•
System Calibration - used to calibrate a sensor to a meter
using a standard ice bath.
DST500 Calibration Software
Probe Rø- The Wahl DST500 & DSX500 include an exclusive
c
ompensation feature utilizing a programmable R
øc
alibration
coefficient for increased accuracy. This allows the meter and
probe to be “matched” to each other, and guarantees an accurate
system.
Probe Rø
W
ahl DST/USB Inter
face
Module, USB Cable, and
Digi-Stem Serial Interface Cable
12360-002 - 4 Conductor
WARRANTY
DST/DSX500 Programming Software
DSTPROG Programming Software Kit - This software allows
the customer to configure the following parameters:
• Sample/Display Rate - Factory default at 1/second.
Adjustable from .25 seconds to 10 seconds in .25 second
intervals. Slower update rates extend battery life.
•
Probe Rø- Compensation feature which allows calibration
of meter to be “matched” to probe.
•
Current Transmitter Programming - Allows assignment of
4-mA and 20-mA values in °F or °C.
• Burnout Setting - controls current direction in event of open
probe. Upscale drives to 22.0-mA and Downscale drives to
3.5-mA.