Instruction Booklet

Hair clipper (mains)
13
begin trimming your moustache, starting at the top and
working down to your upper lip. Use progressively closer
settings to get the look and length you desire.
4. For the tapering of the moustache, set the 5 position
trimming guide at a medium length. Starting at the middle
of your moustache, follow the lip line and taper
with short upward strokes of the trimmer, working out
toward the corners until a gentle shape is created on the
bottom of your moustache.
5. As a nishing tip remove the trimming guide and using
only the bare blades make a denitive line at the bottom of
your moustache.
Battery Installation - Trimmer
1. Remove battery cover from trimmer by pushing in and
back on the plastic door in the direction of the arrow.
2. Important: Be sure to insert the negative (-) end of each
battery rst, so that it depresses the spring at the bottom
of the battery compartment. Then slide the positive (+) end
into position. Do not allow the negative terminal clips to
bend and cut the casing of the batteries.
3. Replace battery cover to its original position.
4. Move switch to ON position to use.
Using Your Nasal Trimmer (Not Included in all Wahl kits)
1. Before trimming remove the protective cap and turn on the
trimmer by pushing the switch up.
2. To trim hair from nose – make sure the nasal passages
are clean. Slowly move the rotary head in and out of each
nostril, no more than ¼ inch deep. Keep the side of the
cutting head rmly against the skin to prevent a tickling
sensation.
3. To trim hair from ears – make sure the outer areas of the
ears do not contain any wax. Hold the ear at with one
hand and carefully insert rotary head no more than ¼ inch
into the outer ear. Caution: Do not insert the rotary head or
any other foreign object into the inner ear. For hair growing
on the outside of the ear, simply move the rotary head
slowly along the edges of the ear.