Instruction Booklet
Hair clipper (mains)
15
OILING BLADES
The blades of your new clipper should be oiled after every
haircut. Simply place a few drops of Wahl Oil on the blades at
points A and B. Switch the trimmer on briey (approx 10
seconds) to ensure the oil lm is evenly distributed. Use only
the Wahl Oil included in the pack. Due to the high speed of your
Wahl Clipper, the correct type of oil must be used. Do not use
hair oil, grease or any oil mixed
with kerosene or any solvent, as
the solvent will evaporate and
leave the thick oil, slowing down
the blades. Wahl Oil is a very thin,
natural oil which will not evaporate
and will not slow down the blades.
Note: Do not over oil! Excessive oiling or application of
liquids will cause damage if allowed to seep back into the
motor.
Power screw (not found on all models of Wahl clippers)
Your clipper has a power screw; it
has been adjusted for peak eciency
before leaving the factory. However,
if voltage in your home is low, you
may need to readjust it.
To adjust power, use the plastic
brush, screwdriver or a thin coin to
turn the power screw in a clockwise
direction until the arm strikes the coil
making a noise. Then slowly turn the
power screw out (counter clockwise), just until noise stops. Then
about a quarter turn more, this is the maximum power setting.