Instruction Booklet

Hair clipper (mains)
16
Blade set is cutting badly.
Blade set is pulling hair out.
Blade set is dirty.
Blade set is worn out
Skin injury
Too much pressure on the skin
Cutting angle is too high
Gap between the front edge of the
bottom blade and the front edge
of the top blade is not correctly
aligned.
Appliance is not working
Defective power supply
Clipper is making a loud noise
Power screw adjustment may be
needed
Clean and oil the blade set
Replace the blade set
Less pressure on the skin
Hold appliance more flatly to the
skin
Align the bottom blade
Make sure that contact between
the appliance plug and the socket
is faultless. Check the mains cable
for possible damage.
Check the power supply
Make sure the power screw is
adjusted correctly. (Refer to page
12 for instructions)
TROUBLE SHOOTING
WIRING INSTRUCTIONS
WARNING: IF THE SUPPLY CORD IS DAMAGED IT MUST
BE REPLACED BY THE MANUFACTURERS SERVICE
AGENT OR A SIMILARLY QUALIFIED PERSON IN ORDER
TO AVOID A HAZARD.