Instruction Booklet

11
Creativa
To recharge the battery:
1. Switch o󰀨 the clipper using the on/o󰀨 switch (Fig. 5b).
2. Press the release button (Fig. 1C) on the side and remove
the battery pack (Fig. 3a).
3. Remove the charged battery pack (Fig. 4) from the
charging stand and slide it into the hair clipper until it
locates with an audible click (Fig. 3b).
4. Fit the at battery pack to the charging stand (Fig. 4). See
section Charging the battery.
OPERATION
Setting the cutting length
The cutting length can be adjusted to between 0.7mm and
3mm (5 possible positions) using the cutting length adjustment
integrated into the blade set (Fig. 6).
Cutting with attachment combs
The appliance can also be operated with attachment combs. In
order to achieve the indicated cutting length, the cutting length
adjustment lever should be set to position 1 (Fig. 6).
Attaching/removing the attachment comb
1. Slide the attachment comb on to the blade set in the
direction of the arrow until it reaches the limit (Fig. 7a).
2. The attachment comb can be removed by pushing it in the
direction of the arrow (Fig. 7b).
CHANGING THE BLADE SET
Removing the blade set:
1. Switch the appliance o󰀨 using the on/o󰀨 switch (Fig. 5b)
and disconnect from the power supply.
2. Push the blade set o󰀨 the housing in the direction of the
arrow (Fig. 8a). Remove the blade set.
Replacing the blade set:
1. Replace the blade set by hooking it into the housing. The
small lug at the base of the blade should be aligned with
the indent on the clipper casing. Press the blade down
until it clicks into position (Fig. 8b).