Operating instructions

7
Rechargeable Trimmer
• If the device is fully discharged, apply a charge right away to prevent
damage or inability to recharge.
• A partial charge is ne; Li-Ion does not require a full charge.
• Charge the device at moderate temperatures. Do not charge below
freezing.
• Do not leave the device connected to the charger when it is not plugged
into an outlet.
NOTE: It is okay to leave the device in its stand for storage if the stand
allows for the charger to be disconnected from the stand or product.
• Perform regular maintenance on the device including keeping the blades
oiled, clean, and free of debris to prevent taxing the battery.
• When not in use, store the partially charged device in a cool and
dry place away from heat sources and direct sunlight ( 25°C Ambient or
less recommended)
WARNING: ONLY USE THE TRANSFORMER SUPPLIED WITH THE
TRIMMER. (For Lithium models please use S004MB0400090 charger. For
non Lithium models, please use SPE024012B charger).
Recharging Your NiMH Trimmer (Models 9854-800 and 9860-806)
1. This Trimmer is conveniently designed for household use. It should be
allowed to charge overnight before rst use.
2. Remove the trimmer, recharging transformer and accessories from the
packaging.
3. Connect the transformer to the trimmer. BE SURE THE TRIMMER IS IN
THE OFF – 0 POSITION WHEN CHARGING.
4. Plug the recharging transformer into any convenient electrical outlet at the
correct voltage.
5. When the trimmer is low in power, it should be connected to the
transformer and plugged into an outlet to assure maximum power is
available when it is next used. This transformer is designed to continuously
charge the battery without over charging.
ZB333 Rechargeable Trimmer Instructions Rev.4 09-18.indd 7 05/10/2018 09:02:42