Instruction Booklet

14
CORDLESS CLIPPER INSTRUCTIONS
OPERATING INSTRUCTIONS MODEL 8877
Keep the packaging for safe storage or transport later.
Check that the contents are complete.
Check all the parts for possible transport damage.
CHARGING THE BATTERY
1.Connect the appliance plug (Q) on the plug-in transformer to the
charging stand socket (G) (Fig. 8a).
•The appliance can also be connected directly to the plug-in
transformer for charging (Fig. 6a/b).
•Intelligent charge management prevents the battery from
overcharging.
2.Connect the plug-in transformer to the mains socket (Fig. 8b).
3.Switch o󰀨 the appliance using the on/o󰀨 switch (Fig. 7b).
4.Place appliance on the charging stand (Fig. 8) or connect directly
to the plug-in transformer (Fig. 6a/b).
•During charging, the charging indicator (C) ashes green slowly.
With a fully charged battery, the charging indicator is constantly
green.
•After the appliance has been removed from the charging stand, the
display goes out after approx. 30 seconds (power saving mode).
•It should take around 80 minutes for the appliance to charge to full
capacity.
BATTERY OPERATION
1. Switch on the appliance using the on/o󰀨 switch and switch
o󰀨 after use (Fig. 7a/b).
•After the appliance has been switched o󰀨, the display goes out
about 15 seconds later (power saving mode).
•When the battery is fully charged, the appliance can be used for up
to 120 minutes without mains connection.
•The charge status of the battery is displayed by the charge
indicator (C):
constant green illumination = 100 % – 20 %
rapid green blinking = 20 % – 5 %
constant red illumination = 5 % – 0 %