Instruction Booklet

9
HOT AIR STYLER
Always ensure the air inlets are free from uff and dust etc. The
inlet grill must be cleared of any build up of uff or hair by using a
small dry brush. Store the appliance away from dust or moisture.
Beginning at the crown area, take a small section of hair (about 2
inches) and place the brush near the root area. Slide the hot air
styler towards the ends, then wind towards the root area.
Hold for 10-15 seconds for medium or thick hair and about 5-10
seconds for ne hair, gently unwind the hair without tension.
AFTER USING THE ATTACHMENTS.
IMPORTANT: The attachments may be hot immediately after
use. Allow the attachments to cool before removal.
REPAIRS
Do not attempt to repair the appliance yourself. Repairs can only
be made by qualied service personal with special tools. Repairs
by unauthorised persons will invalidate the guarantee, and may
result in accident or injury. If the styler fails to work properly when
purchased return it to the retailer from which it was purchased.
CARE AND CLEANING
Always unplug your hot air styler and allow it to cool down before
cleaning. Do not immerse in water or liquids. Use a slightly damp
cloth to clean the unit handle of your hot air styler, and dry thoroughly
with a clean soft cloth.
The attachments may be washed in warm water.
MAKE SURE THEY ARE COMPLETELY DRY BEFORE
PUTTING BACK ON STYLER
IMPORTANT: Do not use harsh abrasive cleaners.
WIRING
WARNING: If the supply cord is damaged it must be replaced
by the manufacturers service agent or a similarly qualied
person in order to avoid a hazard.