Submittal Sheet

WAL-RICH CORPORATION • SPECIFICATION PAGE
CALL [phone] · www.wal-rich.com · FAX [phone]
Con-Stab® Chamfer Tools
Job Name: ____________________________________________
Job Location: ____________________________________________
Contractor: ____________________________________________
Engineer: ____________________________________________
Approval: ____________________________________________
WR# Size Wall Weight
Design Features:
- For Constab® “ID Seal” fittings only
- Pipe Size and SDR Specific
- Made in USA
2888020 1/2” CTS .090 Wall .36
2888014 3/4” IPS SDR-11 .36
2888016 1” IPS SDR-11 .43
2888022 1” CTS .099/.101 Wall .36
2888006 1-1/4” IPS SDR-10 .50
2888007 1-1/4” IPS SDR-11 .50
2888008 1-1/2” IPS SDR-11 .60
2888010 2” IPS SDR-11 .80
Thickness (lbs.)
Before
Square-Cut
After
Chamfered
Test your chamfer by using the “Test Gauge” on your chamfer tool. The
test gauge approximates the o-ring-embedded insert inside each Con-
Stab fitting. Test your chamfer by pushing the pipe over the test gauge.
If the pipe is chamferred properly, it should fit over the test gauge with
minimum effort.
Test Gauge
Follow the arrows printed on the label.
Only 3-5 turns necessary for a good
chamfer!
You must use a
Continental Chamfer Tool
on a Continental Fitting
Always
Match
Pipe Size
& SDR