Instruction Manual

19
Operating Manual Light Control “PULSE PIR - Vers. IV with MFT”
ENG
Explanation of the functions (part 2)
Function 1.4
Write protection
Function for admission or avoid-
ance of setting variations.
The default setting of the function
is „OFF”, i.e., the set levels can be
overwritten at any time.
The levels cannot be changed if the
write protection is active.
The function can be changed on
lights with sensors XXX /R
Function 1.5
Light control
Function for the automatic readjust-
ment of the set brightness in case
the ambient brightness changes.
The default setting of this func-
tion is “ON”, i.e., the light control
is active.
The light is dimmable with the light
control switched off.
The function can be changed on
lights with sensors XXX /R
Function 1.6
Presencecontrol
Function to detect the presence
of persons.
The default setting of this function
is “ON”, i.e., the presence control
is active.
If the function is switched on, the
light automatically switches off, if
for a certain time no presence is
detected.
If the presence control is switched
off, the light functions as a light
with light control or as dimmable
light.
The function can be changed on
lights with sensors XXX /R
Fig. 3
Key I
Logo
Light
bar
Key II
LED I
LED II
Note: The functions written in
blue are not available.