Instruction Manual

22
Operating Manual Light Control “PULSE PIR - Vers. IV with MFT”
ENG
Explanation of the functions (part 5)
Function 2.4
Sensor LED
Function to switch both LEDs in
the sensor operating panel on and
off (see fig. 4).
The function is normally switched
“OFF”, that is, the LEDs in the light
head are switched off.
For lights without the column
operating panel, the function is
switched to “ON”.
If the function is switched on, the
LEDs in the light head light in addi-
tion to the light bar display.
The function can be changed on
lights with sensors XXX /R
if equipped with column
operating panel (MFT).
Function 2.5
Continuous operation
Setting function for continuous
operation.
The default setting of the function
is “OFF”.
The light operates continuously if
the function is switched on. Even
if no presence is detected, the light
lights at the lowest level.
The function can be changed on
lights with sensors XXX /R
Fig. 3
Key I
Logo
Light
bar
Key II
LED I
LED II
Fig. 4
LED II
Key II
LED I
Key I
Sensor
Function 2.6
Parameter setting protection
Function for activating the param-
eter setting protection (required for
final inspection)
By default, the function is set to
"OFF".
When the function is switched on,
a factory reset will not overwrite
the set parameters. The parameter
setting of the electronic ballast
units will be carried out.
he function can be changed on
lights with sensors XXX /R