User Manual

Sound Parameter
51 Blofeld User´s Manual
Mod Source see table „ModulationSources“
Selects the source of the cutoff modulation for the
selected filter.
Mod Amount -64...+63
Controls the amount of cutoff modulation for the selected
filter. Positive amounts will increase the cutoff frequency
when positive modulation is applied, e.g. by pressing the
aftertouch on the keyboard. Negative amounts will
decrease the cutoff frequency when positive modulation is
applied.
FM Source see table „FM Sources“
Selects the source of the frequency modulation for the
selected filter.
FM Amount off, 1...127
Sets the amount of frequency modulation that is applied
to the filter by the selected source.
Drive 0...127
Determines the amount of saturation that is added to the
signal. If set to 0, no saturation will be added or, in other
words, the signal will remain clean. Lower values will add
some harmonics to the signal, resulting in a warm
character. Increasing the value will bring in more and
more distortion, suitable for harder lead sounds and
effects.
Drive Curve
Determines the character of the drive. The following drive
curves are available: Clipping, Tube, Hard, Medium, Soft,
Pickup 1, Pickup 2, Rectifier, Square, Binary, Overflow,
Sine Shaper, Osc 1 Mod.
Pan left 64...center...right 63
Determines the position in the stereo panorama. When
the setting is left 64, the sound is panned far left; when the
setting is right 63, it is panned far right. If you want to
situate the sound in the middle of the stereo panorama,
use the center setting. To give further movement to the
sound, set this parameter to a basic value and apply some
modulation to it via the Pan Source parameter.
Pan Source see table „ModulationSources“
Selects the source of the panorama modulation for the
selected filter.