User Manual

Sound Parameter
67 Blofeld User´s Manual
program. The Overdrive effect, for example, works great
on Organ or E-Piano sounds.
Drive 0…127
Controls the amount of distortion the effect produces. Low
values create no or only slight distortion while high values
create heavier distortion.
Drive Curve
Determines the character of the drive. The following drive
curves are available: Clipping, Tube, Hard, Medium, Soft,
Pickup 1, Pickup 2, Rectifier, Square, Binary, Overflow,
Sine Shaper.
Post Gain 0…127
Controls the output level of the distorted signal.
Cutoff 0…127
Dampens the high frequency output of the Overdrive
effect.
w Please note that the setting of the Mix parameter
doesn’t affect the strength of the overdrive effect but
only the volume of it. Therefore, you can get a very
strong overdrive with a low volume when you turn
up Drive and turn down Mix.
Triple FX
This effect type is a combination of three different effects.
You can easily use this as a replacement for one of the
above mentioned effect types. The quality of Triple FX is
the same as if you use a single effect, only its parameter
set is reduced. The effects and their order is as follows:
• Sample & Hold is a sample rate reduction effect.
• Overdrive is the same as the above described
effect.
• Chorus is the same as the above described effect.
w You should turn the Mix control fully up with this
effect type because you probably want the sample
rate reduction to process the whole signal. The
Overdrive and the Chorus effect have their own mix
control.