User Manual

Sound Synthesis Basics
Blofeld User´s Manual 96
20
Polated
54
19/twenty
21
Transient
55
Wavetrip1
22
ElectricP
56
Wavetrip2
23
Robotic
57
Wavetrip3
24
StrongHrm
58
Wavetrip4
25
PercOrgan
59
MaleVoice
26
ClipSweep
60
Low Piano
27
ResoHarms
61
ResoSweep
28
2 Echoes
62
Xmas Bell
29
Formant2
63
FM Piano
30
FmntVocal
64
Fat Organ
31
MicroSync
65
Vibes
32
MicroPWM
66
Chorus 2
33
Glassy
67
True PWM
34
SquareHP
68
UpperWaves
Filter Introduction
Once the audio signal leaves the mixer, it is sent to the
filters. The Blofeld has two independent filter units, each
with its own individual settings. The signal flow in the
filters can be controlled via the Routing function. The
filters are components that have significant influence on
the Blofeld’s sound characteristics.
For a detailed description of the different filter types that
are available in the Blofeld, see the section “Filter Types”
on page 78. For now, we’ll explain the basic function of a
filter discussing the type used most commonly in
synthesizers: the low pass filter.
The low pass filter type dampens frequencies that lie
above a specified cutoff frequency. Frequencies below
this threshold are hardly affected. The frequency below
the cutoff point is called the pass band range, the
frequencies above are called the stop band range. The
Blofeld’s filter dampens frequencies in the stop band with
a certain slope. The slope can be 12dB or 24dB per
octave. This means that the level of a frequency that lies
an octave above the cutoff point will be 12dB or 24dB
less than those frequencies of the signal that fall into the
pass band. The following picture shows the basic
principle of a low pass filter: