User guide

Multi Mode
25 Blofeld User´s Manual
dial c. The display shows you the actual part
in the left top corner.
To edit a Multi program, press Play and use the Selection
dial c to go through the many parameters of Multimode
Most of the parameters are displayed with graphics.
Bank A...H
Selects Bank A…H from which the Sound program is
taken.
Sound 1...128
Selects the desired sound program.
Cat. Filter miscellaneous
Restricts sound selection to a certain category.
Volume 000…127
Volume sets the output volume of the selected Part.
w This Volume parameter sets the maximum output
volume of the selected Instrument. If you use MIDI
Controller #7 (Channel Volume) to change the
volume of the Instruments that receive on this MIDI
channel, the real output level is scaled to the volume
set up in this parameter. This means that if you set
Instrument Volume to 10 and Controller #7 to 127,
the maximum output volume is 10.
Pan left 64...center...right 63
Determines the panning position of the selected
instrument. The setting left 64 stands for full left, right 63
for full right. In case you want to have the sound in the
mid position select center.
w If stereo effects are active, e.g. delay, the effect will
still sound in both outputs even if the basic sound
is set to full left or full right.
Channel global, omni, 1…16
Channel sets the MIDI Channel for the selected
Instrument. This MIDI channel is used to send MIDI
messages and to receive MIDI messages for this Part when
Status is set to play.