Secure slat 15 to legs (13,14) using large screws (G). Tighten large screws (G) with wrench (J). Repeat this step for the second set of legs (13,14). Secure slat (16) to legs (13,14) using large screws (G). Secure supports (17) to legs (13,14) using small screws (F). Tighten all screws with wrench (J). Repeat this step for the second set of legs (13,14).
Secure umbrella supports (19) to slats (18) using large screws (G). Tighten large screws (G) with wrench (J). Attach slats (18) to slats (15) using large screws (G). Tighten large screws (G) with wrench (J).
Attach slat (5,6) as per diagram. Use small bolts (E), wrench (J) to secure the slat (7) as per diagram.
Secure slat (12) to slats (8,9) using small screws (F). Tighten small screws (F) with wrench (J). Secure slat (11) to slats (8,9) using small wood screws (A). Tighten small wood screws (A) with a screwdriver.
Construct the inner frame of the table by securing the slat (6) assemblies from Step 6 to slats (8,9,10) using large screws (G). Tighten large screws (G) with wrench (J). Carefully slide the leg assembly from Step 4 into place along the inner frame assembly from the previous step.
Secure supports (17) to the inner frame assembly using small screws (F). Tighten small screws (F) with wrench (J). Secure each leg to the inner frame assembly using large bolts (C) and sleeve nuts (D). Tighten large bolts (C) and sleeve nuts (D) onto each other using wrenches (J). Carefully slide table top sections (1,3) into place.
Carefully slide table top sections (2) into place. Carefully flip table over onto a soft surface.Attach draw pull latches (I) to all tablel top sections using latch screws (H) as shown above.Tighten screws (H) with a screwdriver.(Ensuer that draw pull latches (I) can appropriately lock and unlock.) Lock draw pull latches (I).
Secure slat (12) to table top section (2) using large wood screws (B). Tighten large wood screws (B) with a screwdriver. Attach blocks (4) to all table top sections using small wood screws (A) as shown above. Tighten small wood screws (A) with a screwdriver.
To put the extendable leaf of the table away, unlock the draw pull latches. (You do not need to flip the table over to unlock the draw pull latches. The diagram is shown as such for illustration purposes only.
Fold table top section (2) over itself. Rotate table top section (2) so it rests on the inner frame of the table.
Carefully and simultaneously slide table top sections (1,3) together. Lock draw pull latches of table top sections (1,3) together.