Insert wooden dowel (A) into parts (3,4) as per diagram.
Secure cam bolt (B) to part (1) with Philips head screwdriver .
Using cam lock (C) secure part (3) to part (1) with Philips head screwdriver .
Using cam lock (C) secure part (4) to part (1) with Philips head screwdriver .
Put part (6) into parts (1,3,4) as per diagram.
Position bottom panel (2) onto the inserted wood dowels and keep the groove have a good fit with back panel. Use bolt (E) attach part (2) into parts (3,4) with hex key (F) as per diagram.
Using screw (R) secure plastic wedge (Q) to part (6)with Philips head screwdriver as per diagram.
Place sticker (D) cover the holes as per diagram .
Using bolt (G) attach part (8) into part (7) with hex key (F) as per diagram. Note : Do not fully tighten all the bolts .
Using bolt (H) attach part (7) to part (2) with hex key (F) ,and tighten all the bolts .
Using screw (L) attach Europe hinge (J) into part (5) with Philips head screwdriver as per diagram.
Using screw (K) attach knob (N) into part (5) with Philips head screwdriver as per diagram.
Using screw (L) attach Europe hinge (J) into part (2) ,then using screw (L) attach door hinge (M) into parts (3,5) with Philips head screwdriver as per diagram. Open and close the door to make it sure was shut correctly .If necessary ,adjust the screws for a good fit .
Position the assembled unit at the desired location .If necessary, adjust the floor levelers at the bottom of the legs to the level the unit .