Installation Guide

Slots should be vertical for use with Wall Control Accessories
pinterest.com/WallControl
If possible, align panel joint on centerline of the stud (for conventional 16”
stud spacing it is possible to anchor to every stud along the length of the
install if studs are true 16” on center and the first panel is aligned along the
centerline of the first stud)
Quick Tip: Stripping out the mounting holes in sheetrock with the screws
included create a perfect sized hole to hammer the provided anchors into
Quick Tip: To span a
single accessory
across multiple panels,
a penny’s thickness
between the panels
creates the perfect
spacing. Note, this is
not required for any
Wall Control accessory
On all holes where a stud is not accessible, the provided plastic hollow wall
anchors can be utilized in lieu of contact with a stud. Mark the hole position and
drill a hole that can accommodate the anchor used.
Plastic wall anchor (provided) inserted into sheetrock
Panel Face
Mounting screw (provided) passes through panel face to mount
flush with return flange and wall or flat surface into stud, anchor,
or other backing
www.WallControl.com
For
Application Images
be sure to Follow WallControl on Pinterest & Like us on Facebook
facebook.com/WallControl
Multiple Panels
Installation & Assembly