Installation Guide

KEYHOLE BRACKET INSTALLATION

Tools Needed

You will need the following tools for the bracket installation: a pencil, a

level, a Phillips screwdriver, a tape measure and a drill.

Choose Wall Fasteners

You will also need to choose the proper type of wall fastener/anchor for

your needs…for example-wood, masonry or drywall. Whenever

possible it is always a good idea to locate and utilize wall studs.

Step 1

First, determine the location you would like the shelf on the wall by

measuring up from the ﬂoor and lightly mark the desired location on the

wall with your pencil.

Step 2

Using a pencil, make a light marking on the top of the shelf above the

two keyholes (Fig. 1) or where you want to install your 2 keyhole

brackets.

Step 3

Position the shelf against the wall and level. Once the shelf is level,

mark the wall in the same place where you marked the shelf (Fig. 2A )

or brackets (Fig. 2B ) above the keyholes.

Step 4

Using the drill and a 7/32 bit, make two holes in wall and insert the

proper hardware.

Step 5

Make sure to leave approximately 0.25” overhang when inserting the

screws (do not fully insert) Fig. 3

Step 6 Place shelf or brackets securely onto screws. Fig. 4

1/4”

Fig. 1

Fig. 2A

1/4”

Fig. 3

Fig. 4

Wood

Hollow

Solid

Fig. 2B

Shelf

Brackets

Locked

Position

(Hardware not included.)