Product Description
Table Of Contents
- Integration instructions for host product manufact
- 2.3Specific operational use conditions
- 2.4Limited module procedures
- 2.5Trace antenna designs
- 2.6RF exposure considerations
- 2.7Antennas
- 2.8Label and compliance information
- 2.9Information on test modes and additional testing r
- 2.10Additional testing, Part 15 Subpart B disclaimer
- Federal Communication Commission Statement (FCC, U
Integration instructions for host product manufacturers according to KDB 996369 D03 OEM
Manual v01
2.2 List of applicable FCC rules
FCC Part 15 Subpart C 15.247 & 15.407
2.3 Specific operational use conditions
The module is a Wireless module.
Frequency Range: 802.11b/g/n-HT20: 2412 ~ 2462MHz
802.11n-HT40: 2422 ~ 2452MHz
Channel Number: 802.11b/g/n-HT20: 11
802.11n-HT40:7
Type of Modulation: 802.11b: DSSS
802.11g/n: OFDM
Data Rate: 802.11b: 1/2/5.5/11Mbps
802.11g: 6/9/12/18/24/36/48/54Mbps
802.11n: MCS0~MCS7
Antenna Type: Dual band Dipole Antenna
Antenna Gain: 2dBi
Frequency Range: For 802.11a/n-HT20/ac-VHT20:
5180~5240MHz, 5745~5825MHz
For 802.11n-HT40/ac-VHT40:
5190~5230MHz, 5755~5795MHz
For 802.11ac-VHT80:
5210MHz, 5775MHz
Type of Modulation: 802.11a/n/ac: OFDM
Data Rate: 802.11a: 6/9/12/18/24/36/48/54Mbps
802.11n: up to 150Mbps
802.11ac: up to 433.3Mbps
Antenna Type: Dual band Dipole Antenna
Antenna Gain: 2dBi
The module can be used for mobile or portable applications with a maximum 2 dBi antenna. The host
manufacturer installing this module into their product must ensure that the final composit product
complies with the FCC requirements by a technical assessment or evaluation to the FCC rules,
including the transmitter operaition. The host manufacturer has to be aware not to provide information
to the end user regarding how to install or remove this RF module in the user's manual of the end
product which integrates this module. The end user manual shall include all required regulatory
information/warning as show in this manual.
2.4 Limited module procedures
Not applicable. The module is a Single module and complies with the requirement of FCC Part 15.212.
2.5 Trace antenna designs
Not applicable. The module has its own antenna, and doesn’t need a host’s printed board microstrip
trace antenna etc.
2.6 RF exposure considerations
The module must be installed in the host equipment such that at least 20cm is maintained between the
antenna and users’ body; and if RF exposure statement or module layout is changed, then the host
product manufacturer required to take responsibility of the module through a change in FCC ID or new
application. The FCC ID of the module cannot be used on the final product. In these circumstances,