Product Description

ManualsBrandsWallys Communications Technologies ManualsElectronicsDual Band 11AC Wireless Module

http://www.wallystech.com/

a) The modular transmitter has been fully tested by the module grantee on the required

number of channels,modulation types, and modes, it should not be necessary for the host

installer to re-test all the available transmitter modes or settings. It is recommended that the

host product manufacturer, installing the modular transmitter,perform some investigative

measurements to confirm that the resulting composite system does not exceed the spurious

emissions limits or band edge limits (e.g., where a different antenna may be causing additional

emissions).

b) The testing should check for emissions that may occur due to the intermixing of emissions

with the other transmitters, digital circuitry, or due to physical properties of the host product

(enclosure). This investigation is especially important when integrating multiple modular

transmitters where the certification is based on testing each of them in a stand-alone

configuration. It is important to note that host product manufacturers should not assume that

because the modular transmitter is certified that they do not have any responsibility for final

product compliance.

1.6. Label and compliance information

When the module is installed in the host device, the FCC ID label must be visible through a

window on the final device or it must be visible when an access panel, door or cover is easily

re-moved. If not, a second label must be placed on the outside of the final device that contains

the following text: “Contains FCC ID: 2AG7VDR900VX”. The FCC ID can be used only when

all FCC ID compliance requirements are met.

1.7. Information on test modes and additional testing requirements

1.5. Antennas

Antenna type:

External fixed

omni

antenna

2.4GHz band

Peak Gain

2(dBi)

4.9GHz band

Peak Gain

2(dBi)

5150GHz~

5250GHz

Peak

Gain

2dBi)

5725GHz~

5850GHz

Peak Gain

2(dBi)

1.3. Trace antenna designs

1.4. RF exposure considerations

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment .This equipment should be installed and operated with minimum distance 20cm

between the radiator& your body. If the device built into a host as a portable usage, the

additional RF exposure evaluation may be required as specified by 2.1093.