User Manual

Prog (Program) - The Prog knob selects the desired R1 delay program. See the Program section for

more details about each reverb program.

Tune - The Tune knob and switch offer creative control over three additional parameters that allow

further shaping of each reverb program. Simply move the toggle below the knob to select the

parameter you want to control, then use the Tune knob to dial in the right amount of Lo, High, or X.

• Lo: Set the switch to the Lo position and use the Tune knob to adjust the amount of low

frequencies in the reverb. Turn up for a thicker reverb and down for a thinner sound.

• High: Set the switch to the High position and use the Tune knob to adjust the amount of high

frequencies in the reverb. Turn up for a brighter sound and down for a darker sound.

• X: The X parameter controls a different effect depending on which program you are using. To edit

the X parameter, set the switch to the X position and use the Tune knob to adjust. See the program

overview section to learn what the x knob does

Stereo Width: The R1 has a stereo width control built in to all the algorithms. This control is useful for

dialing in how wide or narrow of a stereo image you desire and is saved per preset.

To access this control, set the Tune switch to the X position. Hold down the bypass switch. Once the

bypass knob starts ﬂashing, turn the X knob to change the width of the stereo image – from very

narrow at minimum, to stereo at noon, to enhanced stereo above noon.

A | B | C Bank Switch - The R1 offers three banks for storing presets. Each bank holds three presets

for a total of nine that the user can access without using MIDI. The Bank switch selects which bank

of presets the pedal will access. Bank A is presets 0-2, Bank B is 3-5, and Bank C is 6-8. The presets in

each bank correspond to the Red, Green, and Blue preset LED. The ﬁrst preset in each bank is Red,

the second is Green and the third is Blue.

Bypass Switch - Used to turn the pedal on and off. Click to turn the pedal on and click again to turn

the pedal off.

CONTROLS