User Manual

o To recall a preset:

1. First, select the bank of presets you want to access with the A|B|C switch. The pedal will

automatically recall the red preset in that bank.

2. Next, scroll through the presets in that bank by pressing both stomp switches at the same

time. Each press of both stomp switches will load the next preset until you get back to red

and the pattern repeats.

o To save a preset:

1. First, recall the preset in which you would like to build a new sound.

2. Using the knobs and switches, dial in the desired reverb sound. The preset LED will turn

purple indicating the preset has been modiﬁed.

3. To save, hold down the Bypass and Tap switches until the LEDs stop blinking. The preset is

now saved.

Bypass Mode - The R1 offers three bypass modes. True Bypass, DSP+True Bypass, and DSP Bypass.

In True Bypass mode, the R1 uses relays to bypass the pedal. In DSP+True Bypass mode, the R1 uses

relays to bypass the pedal after the reverb decay dies out. In DSP Bypass mode, the R1 locks the

relays on and uses the DSP to bypass the pedal. The R1 ships in True Bypass mode by default. Use the

following procedure to change the bypass mode:

1. Hold down the Bypass switch while applying power until the preset LED lights up a solid color.

The Bypass LED will also ﬂash until a selection is conﬁrmed.

2. Press the SUS/LATCH switch to scroll to the color corresponding to the desired bypass mode.

a. Red: True Bypass

b. Green: DSP+True Bypass

c. Blue: DSP Bypass

3. Press the Bypass and SUS/LATCH switches simultaneously to conﬁrm selection.

Factory Reset - To reset the pedal back to factory settings, hold both stomp switches while applying

power to the pedal for longer than 10 seconds. After 10 or more seconds, release both stomp

switches and the pedal will be reset to factory default settings.

GLOBAL PREFERENCES