User Manual

Tap Tempo: Tap to control delay or reverb time (depending on what program you’re in).
The tap LED will blink with the tapped tempo, or the tempo set by the Time knob.
Program 1 – Controls the delay time of the repeats
Program 2 – Controls the delay time of the repeats
Program 3 – Controls the delay time of the repeats
Program 4 – Controls reverb time stretching, creating a larger or smaller space
Program 5 – Controls the delay time of the repeats
Dive / Rise: Holding down the tap tempo switch will momentarily shift the clock
rate of the pedal down or up and will hold it at that rate for as long as the switch is
pressed. The direction of the dive can be changed by simply pressing bypass and
tap simultaneously. A green LED over tap will indicate Rise is set and a blue LED will
indicate that Dive is set.
Trails: The Lore can run in Trails or No Trails mode. In trails mode, when you turn the
pedal off, the reverb / feedback decay dies off naturally. In No Trails mode, the decay is
abruptly cut off when you turn the pedal off. The Lore ships with Trails mode on.
To toggle between either Trails mode:
1 – Hold down the bypass switch while applying power to the pedal.
2 - After approximately four seconds the tap LED will rapidly blink for 1 second
confirming you have changed trails modes.
3 – A rapid green LED confirms you are in Trails mode. A rapid red LED
confirms you are in No Trails mode.
4 – Repeat the process to changes modes again.