User Manual

Controls
Feedback: Controls the amount of gain in the first feedback path.
Programs 1, 2, 3 – Controls the amount of delay repeats.
Program 4 – Controls the amount of octave down added to reverse reverb along
with the reverse reverb feedback amount.
Program 5 – Controls the amount of pitched delay repeats.
Regen (Regeneration): Controls the amount of gain in the second feedback path.
Program 1 – Controls the feedback of the reverse reverb.
Program 2 – Controls the amount of octave up delay repeats feeding into the
reverb tank.
Program 3 – Controls the amount of octave down delay repeats feeding into the
reverb tank.
Program 4 – Controls the amount of octave up added to reverse reverb along with
the reverse reverb feedback amount.
Program 5 – Controls the amount of pitched delay repeats.
Mod (Modulation): Controls the amount of modulation applied to the wet signal.
Hold down bypass to adjust mod rate with the Mod knob. You’ll see the bypass LED
flashing at the mod rate when this is active. Release bypass when it’s at the desired rate
and the pedal will remember the setting.
Mix: Controls the amount of wet/dry mix. Fully left = dry, fully right = wet.