User's Manual

900-000230
Rev 0.7
(preliminary)
xBR V4 Installation and User Guide
Page 7 of 18
3 Regulatory Compliance
3.1 Federal Communications Commission (United States)
Regulatory Compliance Information
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
RF Exposure Statement
The device has been found to be compliant to the requirements set forth in CFR 47
Sections 2.1091 for an uncontrolled environment. The antenna(s) used for this
transmitter must be installed to provide a separation distance of at least 35 cm from all
persons and must not be co-located or operating in conjunction with any other antenna
or transmitter.
Professional Installation
Only professional installers trained and authorized by the grantee are permitted to
install the unit and its antenna. Refer to section 5 of this document before installing this
device in any location.
Caution
Any changes or modifications not expressly approved by the manufacturer could void
the user’s authority to operate this equipment.
3.2 UL Certification
This device has been tested to UL Standard 60950-1 and CSA 60950-1-07.