Operating Instructions

LG400 – Operating Instructions
-45-
piece by loosening the screw (a). Then loosen the screw (b). The butt stock can
now be moved or removed/
replaced. To attach a new butt stock, reverse the steps.
11 Adjusting the butt plate and stock length
LG400 Anatomic & LG400 Alutec Expert
To alter the stock length, undo the clamping screw (a), after which the stock
length can be varied by turning the setting
wheel (b). Then retighten the setting wheel
(b) using the clamping screw (a). If the
stock length cannot be extended far
enough, a longer stock can be obtained by
using longer rods (special accessory).
To alter the cheek piece inclination, undo
the clamping screws (c). It may first be
necessary to undo the clamping screw (a)
and to turn the setting wheel (b) towards
the butt plate so that the rods can move
freely.
It is also possible to move the butt plate to
the side. In this connection, be sure to comply with the sports rules. If the butt
plate has to be moved, undo the fastening screws (d). Retighten them once the
butt plate is in the required position.
• Shortest possible setting ranges for shooters/juniors more than 160 cm tall
• Simple release and locking of the stock length
• Knurled screw permits adjustment with millimeter accuracy
• Independent adjustment of butt plate and butt plate attachment
• Removal and fitting in a single operation