Installation Instructions

4
LP500 MATCH AIR PISTOL
1. Place the e-trigger in the frame in such a way that the two marked areas are in contact with one
another (Figs. 3, 4, 5). You may have to open the first-stage travel adjustment screw (a) slightly.
2. Turn the mounting screws into the frame, allowing them to make light contact (Fig. 6).
3. Then tighten both of them securely (approx. 1.4 Nm) (Fig. 6).
2.2 INSTALLING THE M-TRIGGER
1. Place the m-trigger in the LP500 as shown
in Fig. 7. The trigger should make contact
in the marked areas. Then push the trigger
forwards (in the firing direction) until the first
mounting screw can be inserted.
2. Turn mounting screw 1 into the frame. Do not
yet tighten it, because you still must position
the trigger (Fig. 8).
3. To align the m-trigger, push it gently in the
X direction (Fig. 9) and pull the trigger once
(Y). The trigger will slide up, allowing you to
insert the second mounting screw.
Fig. 5 Fig. 6
a
b
Excessive torque can damage the pistol frame! If the torque is too low, the trigger
may loosen!
!
CAUTION
Fig. 8
Fig. 7