Installation Instructions

LP500 MATCH AIR PISTOL

4. Position the second mounting screw and

cock your LP500 using the loading lever.

Then tighten both mounting screws securely

(approx. 1.4Nm).

3. ELECTRONIC UNIT

• A rechargeable battery is used to supply

power. To recharge the battery, use a USB

cable with a Mini-B USB plug and connect it to a computer (Power-Bank etc.) or to the power

charger that is supplied. Approximately 1 minute charging time provides enough power to shoot

100 rounds. Total charging time is approximately 60 minutes. A fully charged battery will last for

about 5,000 rounds. Like all rechargeable batteries, the battery should be charged at least every

five to six months and should not be stored in uncharged condition. Over-discharging can ruin the

battery, in which case it must be replaced. We recommend charging the battery when there are

about 3,000 rounds remaining (the LED flashes three times).

• When not in use the e-trigger will automatically go on standby mode. When in standby, the diode

flashes every two seconds for 20 minutes. For the next three minutes the diode flashes twice per

second. After this the unit turns off completely.

• Remaining power: To see how much battery power remains, squeeze the trigger until the LED

lights up. When you release the trigger, the LED will flash once for every 1,000 rounds remaining.

Low power is indicated by four short flashes followed by a pause.

• While the battery is being charged using the Mini-B USB connector, the LED will light up and stay

on. During charging the electronic unit is deactivated and the trigger does not work.

4. ADJUSTING THE TRIGGER

The trigger settings have been optimized by the manufacturer. They should not be changed unless

there is a good reason. The trigger can be set for either two-stage or single-stage operation. If

adjustment is necessary, observe the following instructions.

Omission of this step can cause damage to the trigger pawl!

CAUTION

Fig. 9

Make sure to check the trigger pull weight each time you replace the trigger!

CAUTION