Installation Instructions

LP500 MATCH AIR PISTOL

First-stage travel:

Turn screw “a” clockwise to reduce the first-stage travel. Turn it counterclockwise to increase the

first-stage travel. For single-stage mode turn in screw “a” until the trigger is released. Then turn the

screw out just slightly (Fig. 5).

First-stage trigger weight:

Turn screw “b” clockwise to increase the first-stage trigger weight; turn the screw counterclockwise

to reduce it (Fig. 5).

Second-stage trigger weight:

Set the second-stage trigger weight using screw “c”. Turn the screw clockwise to increase the

weight. Turn the screw counterclockwise to reduce it (Fig. 10/11).

Trigger stop:

Turn screw “d” clockwise to reduce the second-stage over-travel. Turn the screw counterclockwise

to increase it. The second-stage over-travel is shorter in the e-trigger (Figs. 10/11).

If the second-stage over-travel is set too short, the trigger may not work.

CAUTION

If the second-stage weight is set too low, the trigger will not work.

CAUTION

Fig. 10 Fig. 11