Instruction Manual

ENGLISH
16
4.2 Striker Assembly
4.2.1 Remove Striker Assembly
• Field-strip the pistol. Place the muzzle end of the slide
on a smooth, flat surface.
Grasp the slide at the slide serrations, push in the pin
through the square opening located at the top right
side of the slide end cap using a 2 mm punch
(4.2 Fig. 1) and remove the slide end cap by sliding it
downwards (4.2 Fig. 2).
• Remove the striker assembly from the slide
(4.2 Fig. 3).
− P99 AS and P99 QA
Removing the striker assembly will release the
decocker/field-stripping aid. Cover the decocker/field-stripping aid while you
remove the striker assembly, then remove the decocker/field-stripping aid.
− P99 DAO
Removing the striker assembly will release the drop safety. Cover the drop
safety while you remove the striker assembly, then remove both parts of the
drop safety (4.2 Fig 4).
4.2.2 Install Striker Assembly
• Insert Striker Assembly
− P99 AS and P99 QA
Insert the decocker/field-stripping aid from the top of the slide and depress it
just enough so that it is flush with the surface of the slide while inserting the
striker assembly from the rear.
− P99 DAO
Place the slide upside down with the muzzle facing to
the left. Hold the drop safety by the spring and insert
as shown in 4.2 Fig. 5. Insert the second part of the
drop safety. While maintaining pressure, line up the
second part flush with the slide. Insert the striker
assembly.
• Using the slide end cap, press the striker assembly into
the slide and reinsert the slide end cap from the bottom of the slide until it snaps in
place (see 4.2 Fig. 2).
4.2 Fig. 1
4.2 Fig. 3
4.2 Fig. 4
4.2 Fig. 2
4.2 Fig. 5