Instruction Manual

ENGLISH

CAUTION: Always follow the instructions provided with the gun cleaner and

gun lubricant. Some cleaners can cause damage to the pistol. You should

avoid prolonged solvent immersion and prolonged ultrasonic cleaning of the

pistol (maximum temperature for ultrasonic cleaning: 50 °C (122 °F)).

Choice of solvent should be restricted to those products specifically developed

for firearms maintenance. Damage to a firearm’s finish may occur if these

warnings are ignored.

Ammonia based solvents or other strong alkaline solvents, should not be used

on any WALTHER firearm.

4.6 Lubrication

After cleaning the entire pistol, use a cloth to apply a light film of high quality gun

lubricant to all external metal surfaces and wipe clean.

Do not over-lubricate the pistol to the extent where lubricant will be dripping or

running down the handgun. Excess lubricant can attract dirt, unburned powder and

carbon residue, which can interfere with proper functioning of the pistol. Do not put

any gun lubricant into the striker channel (4.6 Fig. 1).

• Barrel:

Use a cloth to apply a light film of high quality gun lubricant to all external surfaces

and the ramp where the locking block cams the barrel.

• Frame:

A light coat of high quality gun lubricant should be applied to the mechanism. Put

only one drop of lubricant on the slide guides, and on the trigger bar.

Put a drop of lubricant on the trigger bar guide on the right outer side of the sear

housing assembly (if applicable).

• Slide:

Put only one drop of lubricant on the striker and on the safety plunger.

P 99 DAO: Put a drop of lubricant on the drop safety.

• Magazine:

Apply a light film of high quality gun lubricant to all external metal surfaces.

4.6 Fig. 1: Lubrication Points

DAO