Instruction Manual

26
4.2 Fi
g
.3
4.2 Magazine
WARNING: WEAR SAFETY GLASSES EVERY TIME YOU ASSEMBLE OR
DISASSEMBLE YOUR MAGAZINE.
4.2.1 Disassembly
WARNING: The magazine spring is under pressure. Use
caution when stripping down the magazine. Control the
floorplate catch and the magazine spring while you
remove the floorplate so that they do not fly out and
cause injury.
1. Using a .15” (4 mm) punch, depress the floorplate catch
through the hole in the floorplate (4.2 Fig. 1).
2. Slide the floorplate forward off of the magazine tube while
continuing to depress the floorplate catch in the tube.
3. Remove the floorplate catch and spring carefully from the magazine tube through
the bottom of the tube.
4. Turn the tube right side up and remove the follower through the bottom of the tube.
4.2.2 Assembly
1. Install the follower and magazine spring plus floorplate catch in reverse order back
into the tube in exactly the same orientation as they were in when they were first
removed during disassembly (4.2 Fig. 2 and 3). Never use excessive force when
assembling the magazine.
2. While holding the floorplate catch in the tube, slide the floorplate onto the tube so
that the round projection of the floorplate catch engages the hole in the floorplate.
There will be an audible “snap” heard.
4.2 Fig. 1
4.2 Fig. 2