Operation Manual

installation, servicing and user instructions manual | GB + IE

2. User instructions

2.1 First Time of Operation

Before igniting the appliance, ensure that all packaging, safety stickers and any protective wrapping have been

removed, and that the glass has been cleaned, including all ngerprints from the glass.

Ensure that the room is adequately ventilated the rst time that the appliance is ignited; we would recommend

opening windows if possible. Run the appliance at full setting for a few hours so that the paint gets an opportunity

to fully cure. During this period it is possible for some fumes and vapours to be given o. We would recommend

keeping children and pets out of the area at this time.

2.2 Remote Control Overview

This Wanders Gas Appliance has been constructed with an advanced remote control system. This consists of three

main parts; Handset (g. 1.1), Receiver (g. 1.2) and Gas Valve with Manual Override (g. 1.3). The Gas control valve

and the Receiver are behind the access door. This is also where the product Data Label is located.

• The Remote Handset has 4 Buttons; these will perform all

operations of the re.

• Always leave the dial on the Gas Control Valve set to "ON", the

"MAN" position is only for servicing and emergency use if the

handset is misplaced, or the battery fails.

• With each successful button press of the handset, the receiver

will emit an audible signal.

• A toggle switch is present on the Gas Control Valve; this should

be put into the "O" position if the appliance is not operated for

a long period (over a week).

• The heat output can be manually adjusted by turning the

setting knob on the Gas Control Valve.

g. 1.2. Remote Receiver

g. 1.1. Remote Handset

g. 1.3. Gas Control Valve