Operation Manual

6
2.3 Batteries
Remote Handset:
1 x 9V "PP3" Battery, Quality alkaline recommended
Receiver:
4 x 1.5V "AA", Quality alkaline recommended for maximum life.
An alternative AC Mains Adaptor may be used to power the Receiver instead of the 4 AA batteries. Only an AC
Mains Adapter supplied by Wanders may be used. The Mains Adaptor is plugged into the DC 6V socket on the end
of the receiver.
Note - if the AC Mains Adapter is used, remove the 4 AA's from the Receiver, failure to do so could result in damage
and failure of the Receiver. During a period of power outage, the receiver may be unplugged and batteries returned
to the Receiver.
2.4 Replacing the batteries
Handset:
There is a battery level indicator on the display of the handset. When this gets low remove the cover on the rear of
the handset and replace the battery with another 9V PP3 battery.
Receiver:
Three short audible beeps will sound when the appliance is on to indicate that the batteries in the receiver are
getting low.
When the batteries get very low the appliance will be turned o by the remote control. This will fail to happen if
the power supply is interrupted.
To replace the Receiver batteries, slide the cover o of the top of the receiver and use the ribbon to pull the
batteries out. Replace the batteries with new 1.5V AA's, ensuring that the ribbon is located under the batteries and
that the polarity is correct on all 4 batteries.
Never mix new batteries with old; this will result in the new batteries being emptied very quickly.
When the batteries are replaced, it may be necessary to reset the transmitter code, as detailed in the next section.
2.5 Setting the Transmitter code
Press and hold the RESET button with a sharp object (pen or screwdriver) until you hear two audible beeps. After
the second, longer beep, release the RESET button.
Within the next twenty seconds press the down button (Button D g 1.1) on the remote handset until you hear an
additional long signal conrming the code is set.
2.6 To Ignite the appliance
Note - If this appliance is extinguished or goes out in use for any reason, wait 3 minutes before attempting to
relight the appliance. The Gas Control Valve has an interlock device which will not allow relighting until the 3
minutes have passed.
To be able to use the Remote control Handset (g. 1.1), the rocker switch on the Gas Valve, must be turned "ON"
(the "1" position) and the manual Dial set to the "On" position.
• Simultaneously press and hold buttons B & C (Star and Large Flame), until a short acoustic beep conrms the
start sequence has begun; release the buttons.
• Continuing signals conrm the ignition is in process.
• Once pilot ignition is conrmed, there will be gas ow and the main burner will ignite.
• Repeat process if pilot ignition fails.
2.7 To Turn the appliance OFF
Press the OFF button (Button B g. 1.1) on the Handset. This will extinguish all Burners including Pilot.