User Manual

-
3
-
【How to Use Connection 】
" 1 ": Open the package, receive the machine card on the antenna
accessories: use the following connections: Voltage DC:
6V-13V/
500mA
«2»
: Control the volume of the audio equipment to the minimum first;
plug in the wireless microphone receiver and connect the audio
cable
(about 1.2 meters of audio cable, one end is connected to the socket
of the wireless microphone receiver; the other end is connected to the
MIC socket of the audio equipment ; connected to the power
supply and turned on .
«3» : There is a touch switch under the battery display on the
microphone. Press it to turn on the microphone. The microphone
has an
IR
position. The touch switch button is the frequency
selection button.
《 4 》 : When the microphone is turned on, the microphone will be
automatically detected within
3
seconds to
5
seconds, and the
RF
light of the signal connected to the receiver will be on
for a long time
《
5»
: Each set of microphones is for the use of locked
special-purpose microphones, and can also be used in multiple sets …
UD Lock Code / Code Operation]
1.
Turn off the receiver first, [press and hold the frequency
selection button while the wireless microphone is turned off, and
press the switch button again without releasing it]; after the
display flashes for about 2 seconds, release the two buttons, and
then turn on the power switch of the receiver , at this time, the
wireless microphone receiving " RF " indicator on the receiver panel