User Manual

Table Of Contents

【Restore Factory State Operation】

When the microphone cannot be connected to the receiver due to

misoperation or other reasons, it can be restored to the factory state

through the reset setting at this time.

The operation is as follows: first turn on the power switch of the

wireless microphone receiver. In the case of not installing the

battery, press the [frequency selection key of the microphone; hold],

then 2 seconds after the battery is installed, and

release the frequency

selection key after 2

seconds ; the microphone will be restored to the

factory settings. [The same operation method is used for conferences

and lavalier clips ...] Later... [Re- operate the

lock code again]