User manual

23
Cleaning Air Filter（Fig 26）
• Take apart the bolt of air filter cover.
• Take out filter element.
• Compress air or use dry brush to clean filter element.
• Do the above opposite to reinstall the air filter.
NOTICE：
• Do not use gasoline or low burning point solvent to clean paper
filter element.
Battery maintenance（Fig 27）
It is adopted the airtight battery (don’t add water）
Notice: Do not take apart the airtight
• If the motorcycle have not been used for a long time. Taking off
the battery and putting it into a dry and place。
• The head of battery was corroded, please take it off and clean.
(Can use boiled water)
NOTICE: turn off the ignition switch, take apart negative pole ○
-
first,
but install positive pole ○
+
when you are installing.
Fig 27
Fig26
24
Adjusting Idling speed（Fig28、Fig29）
The carburetor is in the best situation before sale, if the carburetor is still
influence riding. Please adjust it under the instruction of professional man.
• Warm up few minutes before start
• Adjust idle screw (1) to improve idle speed slightly to enter to
fasten, withdraw it than screw slowly after stocking to fasten to
mix and then rapidly, to stabilizing the position at most, then
withdraw slowly, get and stabilize the position the lowest.
• After adjust idle, then adjust accelerograph handle to free path for
2-4mm,then use adjustor (2) to adjust, screw down nuts, and then screw
up it after adjust.
• Adjusting the idle speed, it should be able to suddenly strengthen the throttle, the
rotational speed of the engine should be excessively steady, no temper and
flameout, stop working or arrange organ not to flameout at being last throttle.
Fig29
Fig28