User manual

Replacing engine oil and cleaning strainer

Replacing engine oil（Fig30）

Suggestion engine oil: SAE 10W/40

• Change the engine oil before engine cold, and under the condition of steady

of motor.

Cleaning strainer

• Take out oil hole cover and oil filter (1) then take strainer (2) and spring

(3).

• Using liquor clean the strainer.

• Install oil filter then take strainer and spring.

• Replenish the standard engine oil to upper limit line of the oil hole cover.

• Install the cover of hole and liter.

• Start engine and keep for few minute then flameout..

• Measure the lever of engine oil again, makes sure it is not leak.

Fig30

Replacing gearbox oil（Fig 31, Fig32）

Suggestion gear oil: SAE 80W/90

Oil container

replacing capacity：0.18L

• Make the motorcycle on the stand

• Take apart the immiting bolt (1), and the spilling bolt (2)

NOTICE: The engine must be warmer when spilling and the

vehicle must be steady by main stand. Make sure the Engine

is empty

• Reinstall the spilling bolt after clean. and screw up.

• Inject 180ml to engine through immit bolt

• Install immit bolt and screw up.

Fig3

Fig31