User's Manual

ManualsBrandsWanlida Group ManualsCamera & PhotoWireless Reversing Camera

Your GPS device comes with a wireless reversing Camera. When the rear gear is

engaged, the image from the camera will be displayed on the screen of your GPS device,

aiding you in parking in difficult spots (works if camera is linked to the reversing light).

Included with the reversing camera are the following fitting parts; License Plate Bolts,

Wedge shaped mounting shims. These parts should be sufficient to mount the camera to

most vehicles. However, some vehicles may require additional parts for fitment.

WARNING: This device, as well as all other wireless devices, may be subject to

interference. Interference may be caused by cell phones, Bluetooth headsets, Wi-FI

routers, power lines and other various electrical equipment, etc. Also note that holding

the GPS unit in your hands may also result in interference.

Camera Installation

You may mount the camera using the license plate’s top or bottom mounting bolts or

screws. When mounting the camera you must make sure that it’s field of view is not

obstructed. Depending on the vehicle, you may mount the camera on the top or bottom

of the license plate. You can use the wedge shaped shims to alter the angle of the

camera during fitting, so that the best view is achieved.

1. Loosen the license plate bolts/screws, then remove the rear license plate.

2. Insert each license plate bolt into a supplied wedge, then through the bolt holes of

the camera, then through the remaining wedges and the license plate. (Fig.1)

3. Align with holes on vehicle and temporarily tighten the license plate bolts. The

wedges will angle the camera down.

4. You will need to choose a route for the camera’s power cable through the vehicle’s

body to the reverse light circuit.

5. Some vehicle’s may have a hole available to pass the wire through, you can use an

existing opening (Fig.2) like where a license plate light is mounted, or drill a hole

close to where the power cable is attached to the camera. (Fig.3) Once you have

chosen where the cable will enter the vehicle’s body, remove the camera. If you

able to use an existing opening, skip the next two steps.

Fig 1

License Plate

edge

Summary of content (4 pages)

PAGE 1
Your GPS device comes with a wireless reversing Camera. When the rear gear is engaged, the image from the camera will be displayed on the screen of your GPS device, aiding you in parking in difficult spots (works if camera is linked to the reversing light). Included with the reversing camera are the following fitting parts; License Plate Bolts, Wedge shaped mounting shims. These parts should be sufficient to mount the camera to most vehicles. However, some vehicles may require additional parts for fitment.
PAGE 2
Fig 2 Fig 3 6. If you are going to drill a hole, choose a location as close to the camera where the power cable comes out of it. Before You Drill A Hole You Must Check And See What Is Behind Where You Are Drilling. If there are any vehicles components, such as electrical parts or fuel system components behind where you are drilling, you must take whatever precaution is necessary not to damage them. Remove the license plate and camera before drilling. 7.
PAGE 3
wire is the negative wire. 11. After determining which wire is the positive and which is the negative, turn off the ignition key, then remove the battery’s negative cable. 12. Wire the camera directly to the reverse light circuit by stripping the reverse light wires then twisting the camera wires to the exposed reverse light wires (ideally these should then be soldered to form a secure connection). Once connected, wrap with electrical tape.
PAGE 4
Fully tighten the license plate bolts. Route all wires behind interior panels or under carpeting so they are hidden. Use cable ties to neatly gather all excess wire. Note: Keep camera lens and the GPS unit screen clean to ensure optimum picture quality. Camera Operation Once fully fitted into the vehicle the operation of the reversing camera is simple. Whenever you put the vehicle into reverse, the camera picture will automatically appear on the GPS unit display.