User's Manual

11
4 Getting Started
4-1 Install the Rechargeable Battery
Power the Notebook PC before using it. There are two ways to power the Notebook
PC: Use the AC Adapter to power it or use the removable Battery Pack.
The Notebook PC is designed to work with a removable Battery Pack. Your
Notebook PC may or may not have its Battery Pack installed. If your Notebook PC does
not have its Battery Pack installed, using the following procedures to install the Battery
Pack:
Place the Battery Pack into the card-slots
of the Notebook PC toward ① and then press it
toward ② to Battery Pack.
4-2 Remove the Battery Pack
1. Turn off the Notebook PC，and disconnect all
lines.
2. Shut down and turn over the computer to
access its base in flat and clean work surface.
3. Slide the Battery Latch toward the arrow ①
and slide the Battery Latch toward the arrow
②.
4. Pull the Battery Pack out from the Notebook
PC toward ③.
While you don’t need to use the WIFI network, press <Fn>+<F2> to turn off
and it can increase the usage time of the Battery Pack.
WARNING! For safety reasons, DO NOT disassemble the Battery Pack, DO
NOT short the circuit, DO NOT throw the Battery Pack into fire and keep it
away from children.
When the Notebook PC with Battery Pack (disconnect the adapter) turns on,
the Power Indicator will turn on. And the light will turn off when in standby
mode or system halting.
DO NOT attempt to remove the Battery Pack while the Notebook PC turns on,
as this may result in the loss of working data.
Damage may occur if you use a different adapter to power the Notebook PC or
use the Notebook PC’s adapter to power other electrical devices.