User Manual TRAFFIC ALARM C007
Precautions Due to the different heat insulation and explosion-proof films on the front glass of the car, it may take about 1-5 minutes to successfully locate the device for the first use. When passing through confined spaces such as tunnels, underground parking lots, or high-rise urban areas, there will be no voice announcements due to weak GPS signals, and the equipment will return to normal after leaving the above areas.
steps are as follows) 1. When using as a dashcam partner, unplug the power cord of the dashcam from the socket and insert it into the DC-5V port of this product ( see ① below), and plug the mini to micro cable in the accessory kit To the 5V voltage input of your dashcam, plug the other end into the other DC-5V port of the device (see ② below). ② ① 2.
When you turn on the power, you will hear the ringtone (When using for the first time, it takes 1 to 5 minutes to search the satellite signal). After that, the device works properly.
Button function This product uses a convenient single-button operation mode. It will start automatically when you turn on the product. 【Press and hold】the button for about 3 seconds to enter the data upgrade state. 【Press】the button to adjust the volume. When the volume is at its maximum, press the button once to turn it down. You can choose from eight levels of volume. Data upgrade 1.
2. Connect the device to your computer using a USB cable (the computer must be connected to the network). Then a window will pop up on your computer and you can click Update to update the data. Troubleshooting 1. Unable to power the device ① Make sure that the charging port of the car works properly.
② If the device is connected with a dashcam, check that the power of the dashcam is turned on normally. 2. Continuous anomaly warning ① Turn off the power and restart or re-upgrade data; ② Check if the device is damaged. 3. Slow satellite connection ① Check if there are any skyscrapers or trees around. ② It takes 1 to 5 minutes to search for satellites for the first time. ③ Start after leaving the underground or tunnel, or wait a few minutes until satellite positioning is completed. 4.
③ Contact after-sales service and report the location of the failure. 5. GPS device is down ① Record the location of the downtime. ② Connect to the computer and upgrade the database software again. ③ Please report to the product seller. If you have any questions, please contact us at service@ spedaltech.com For more information,please scan the QR code on the right side to visit our homepage and read the detailed manual.
FCC Warning This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any inte rference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
